The board is provided with:
The Microchip RN2483 module provides LoRaWAN™ protocol connectivity using a simple UART interface. The NXP MKLS26Z is connected to the Microchip module using the configuration 57600 8N1 without using RTS, CTS lines.
The connection used by RN2483 is ABP (Activation by Personalization). To use this connection it is required to setup the RN device only one time. Every Lora Sensor Node bought is already configured. The commands used were:
sys factoryRESETsys get hweuimac set deveui [hweui key read]mac set devaddr [last less significant hexs of hweui key]mac set appskey AFBECD56473829100192837465FAEBDCmac set nwkskey [hweui key repeated two times]mac save
After saving this setup is not required repeat the opeation of setup. In order to send data in the Lora network the two used commands are:
Please refer to architechboards website.